What are Pyramids?

Most of you must have heard the word pyramid. It is a Greek word meaning ‘Fire in the Center’. Hence we can understand that pyramid produces energy at the center or rather it is an energy generator.

According to the law of conservation of energy which is accepted by the scientific community, energy can neither be created nor destroyed. It can change from one form of energy to another. We see this all around us in our daily life. Electric energy gets converted into light energy to brighten our homes, gets converted into heat energy to heat the bathing water and gets converted to mechanical energy to drive the pumps etc.

Thus if the pyramid has to supply energy or if the energy has to get liberated at the center then this energy will have to be obviously supplied from the surrounding space. As mentioned earlier we live surrounded by various types of energy and it is this energy which enters the pyramid from the various sides and interacts inside to release another form of energy.

A pyramid is basically an object which has four triangular sloping sides with a flat base. See the following figure to understand the structure of a pyramid. The tip of the pyramid is pointed and is called the apex.

Pyramids abound in Egypt which is called the land of pyramids. The world’s largest pyramid called the pyramid of Giza is found here. This pyramid is estimated to be about 450 feet high and is estimated to comprise two million stones. The granite blocks used here weigh somewhere between two to seventy tons. Even today it is a mystery as to who built it and when. Various theories have been proposed, but none have been accepted as final.

Experiments carried out on small pyramid models essentially conforming to the dimensions of the pyramid of Giza of have conclusively proved that, inside the pyramid a distinct atmosphere exists which is protective and energy giving. It also appears that the energy emitted from the apex and from the base are like the male and female parts of bioenergy and the energy which is released at around one-third the height from the base inside the pyramid is akin to bioenergy.

Experiments have also shown that the energy which gets released from the apex is hot in nature whereas energy released from the base is cold in nature. Probably the three types of energy released from the pyramid are comparable to the Data, pitta and kapha concepts of ayurveda and the pyramid is a device where all these three forces exist in harmony. Pyramids are being used for rejuvenation and healing all around the world.

Alignment of the Pyramid

The pyramid of Giza is so aligned that one of the sides faces exactly towards the north. Normally in experiments which are carried out to tap the energy, this alignment is made use of. It is also observed that irrespective of the alignment, a certain energy gets continuously released inside the pyramid. But if the alignment is disturbed, it does not mean that the energy inside completely disappears. It only means that it is not working at an optimum capacity.

When the pyramid is so aligned that the four sides face the four cardinal points, it is said to be in the axis. Yet another method of alignment tried out by me is cross aligning the pyramid where the four faces look at northeast, southwest, northwest and the southeast instead of the north, east, south and the west.

In Vaastu these directions are basically more important than north, south, east and west. All those who have studied this science are well aware that the defects in these directions produce far more serious effects than the defects in the east, north, south and west directions.

Taking a cue from here I conducted experiments by aligning the pyramid on its edges in a way that each edge faced towards each cardinal direction. See the following figures.

It is interesting to note that pyramids with eight faces called Astamoga pyramids appear to have energy which is several times the energy produced in a regular pyramid. In an astamoga pyramid, while four faces are aligned towards the north, east, south and the west, the other four faces are aligned towards the southwest, northeast, northwest and southeast respectively.

It appears that the extra energy which gets released in the astamoga pyramid is primarily due to the energy interaction from the four cross directions. A pyramid which is aligned on a cross axis functions much better as far as the effective elimination of Vaastu defects are concerned.

I would, however, like you to try both the straight and the cross alignment and then come to the conclusion as to which one works best in your plot. This is because it is difficult to determine which sector is defective in a plot. It could also be a case of the involvement of more than one sector. Thus if the defects of the north, east, west and south sectors are causing the problem then aligning it as per the standard practice could be better. If on the other hand the cross directions namely northwest, southwest, southeast and northeast are involved, then it is better to cross align the pyramids for Vaastu corrections.

In the figure given below BC is called as the base and AB and AC are called as the sides. The point A is called the apex.

In the case of a pyramid, BC will be equal to 9.5″ and the sides AB and C should be 9″ each. In other words, the side AB is equal to side AC. Four such triangles will be required to make the pyramid. See the following figure to understand how the pyramid looks.

The pyramid has to be buried in the soil, hence wooden pyramids should not be used for the purpose. Moreover it is difficult to control the dimensions while dealing with such small sizes in wood.

Plastic pyramids are the best. These can be made from PVC and bakelite.

We shall now see how to correct the angular defects by using pyramids.

Angular defects arise due to the extension of a corner of a plot at a particular angle other than the northeast. Angular projection towards the northeast enhances the quality of the plot and should be retained for best benefits. In such a situation no correction is called for (Fig 52).

However when the angular projections are towards other directions, then corrections are called for See the following figures. You will see that the plots have defective projections towards the northwest, Southwest and the southeast in figs. 55, 56, 57.

In these cases the normal procedure recommended for the correction of the plot is by building compound walls so as to carve out the maximum rectangle or square from the distorted plot. The areas that can be carved out if this procedure is adopted is shown in the dotted lines in Fig 58.

However this is not always possible although it is desirable. In these cases and also where the building has come up, pyramid correction is to be considered.

Installation

To nullify the effect of a strong northwest, draw a line which would correct the plot to form a rectangle. Install a pyramid on the point where the line from the southwest meets the line from northeast. One more pyramid to be installed at the point where the bisector of the angular defect meets the imaginary line.

In a plot where the southeast is projecting, the pyramid should be placed at the intersection of the straight lines drawn from the northeast and the southwest as shown below. (Fig 59)

In a plot where southwest is projecting, the pyramid should be placed at the intersection of the two straight lines drawn from the southeast corner and the northwest corner as shown below. (Fig 60)

The installation of the pyramid is to be done as under:

(i) Dig a pit of about 30cmx30cm, with a depth of 20cm. The pit must be a square and the center of the square is the point where the two lines drawn, as explained above, intersect.

(ii) Place a white marble slab of a thickness of about 10mm at the bottom of the hole. Likewise cover all the four sides of the pit with white marble slabs.  

(iii) Now with the help of a compass locate the exact north axis. First place the pyramid so that one of the faces aligns with the axis. The I apex must be right above the intersection point. Cover the pit with coarse sand, but let the apex remain visible and leave it in place.

The trial period is about two weeks and by that time you should notice some improvement because of the correction. If this does not Jhappen realign the pyramid so that the faces look towards the northwest-southeast. If the first alignment does not work, the possibility is the second alignment will work.
The pyramid combination to be installed in an irregular plot is discussed in the following chapter.